Terminal Blocks
Product beschrijving
Screw-terminal blocks are ideal suitable to reach functional perfection in every detail. They are an essential part of a reliable and safe electrical installation on board.
The terminals are available for wire sizes from 1.5 - 16 mm². Closure clip for top hat rail mounting. Grey terminals for "positive" wire, blue terminals for "negative" wire. The blue terminals (-) can be interconnected via a bus to a common ground. The terminals up to 2.5 mm² are also well suited for data and control lines. All terminals are supplied separately. Available in different sizes.
Note
- We often are asked how the common busbar (Art. 63801) is mounted on the blue terminal blocks.
This can be quickly explained by looking at the picture of the blue terminal blocks.- There is a round opening on the top of the terminal. A screw can be seen a little deeper inside.
This side of the terminal block is for connecting a wire. - We also see an oblong hole in which there is also a slightly deeper screw.
This side of the terminal block is intended for the MINUS busbar. - Loosen this screw with a suitable screwdriver (do not unscrew it completely!).
- Slide the loosened screw with the screwdriver to the other side of the oblong hole.
At the same time, push the clamping mechanism for the MINUS busbar out of the housing - and that's it! - Loosen the screws of all blue terminal blocks until you can slide the clamping mechanism of each terminal over the MINUS busbar.
- Re-tighten the screws.
Important: The clamping mechanism does not grip over the entire width of the MINUS busbar.
Make sure that the busbar is inserted into the clamping mechanism as far as possible.
Tip: When all terminals are mounted on the DIN rail, mount the MINUS busbar first on the first and last blue terminal blocks, then on the terminal blocks in between.
- There is a round opening on the top of the terminal. A screw can be seen a little deeper inside.
- We do not have special accessories such as locking blocks, side covers, integrated fuse holders or bridges in our product range. If required, you can find these parts in well-stocked electrical retailers.
Klanten kopen ook
Vergelijkbare producten
Customers ask customers
Ask other SVB customers who have already purchased this product from us for your experience.
Your question will be automatically forwarded to other SVB customers and your question will be published on the product page. Please do not pose any questions which can only be answered by the SVB team – such as the status of an order or product availability. You are also more than welcome to contact our SVB team by email at: info@svb24.com or by phone at: +49 (0)421-57290-0 .
- More "Customers ask customers" available in the following available languages :
-
-
-
